User Guide for the SIP-T46S IP Phone
116
Using the speakerphone
Using the headset
You can also dial the number first, and then choose the way you want to speak to the other
party.
You can also search and dial a contact from call history, local directory or remote phone book.
For more information, refer to
and
on page
During a call, you can alternate between Speakerphone, Headset, and Handset modes by
pressing the Speakerphone key, the HEADSET key, or by picking up the handset.
The call duration of the active call and far-site’s information (name or phone number) are visible
on the LCD screen. In the figure below, the call to “1026” (the phone number: 1026) has lasted
15 seconds.
To place a call using the handset:
1.
Pick up the handset.
2.
Enter the desired number using the keypad.
3.
Press , , or the
Send
soft key.
The # key is configured as a send key by default. You can also set the * key as the send key, or
set neither. For more information, refer to the
Note
To place a call using the hands-free (speakerphone) mode:
Do one of the following:
-
With the handset on-hook, press or the line key to obtain a dial tone.
Enter the desired number using the keypad.
Press , or the
Send
soft key.
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone, press the
OK
key when the phone is idle. The maximum length of SIP URI or IP address length is 32
characters. For example, SIP URI: 3606@sip.com, IP: 192.168.1.15 (192*168*1*15).
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
Summary of Contents for SIP-T46S
Page 1: ...aji...
Page 26: ...User Guide for the SIP T46S IP Phone 16...
Page 230: ...User Guide for the SIP T46S IP Phone 220...
Page 235: ...Appendix 225 Appendix B Menu Structure...
