User Guide for the SIP-T46S IP Phone
166
Configuring Transfer Mode on DSS Key
When there is an active call on the IP phone, you can handle the active call differently
depending on the configuration of transfer mode via Dsskey with the BLF key.
To configure the transfer mode on DSS key via web user interface:
1.
Click on
Features
->
Transfer
.
2.
Select the desired transfer mode from the pull-down list of
Transfer Mode via Dsskey
.
If you select
Blind Transfer
, press the BLF key to blind transfer the call to the
monitored user.
If you select
Attended Transfer
, press the BLF key to dial out the monitored phone
number and then perform an attended or a semi-attended transfer.
If you select
New Call
, press the BLF key to place a new call to the monitored user.
The original call is placed on hold.
3.
Click
Confirm
to accept the change.
Note
Using BLF Feature on the IP Phone
You can use the BLF key in the following ways:
Place a call to the monitored user.
Transfer a call to the monitored user.
Pick up an incoming call of the monitored user.
Placing a Call to the Monitored User
You can press a BLF key to dial out the monitored phone number when the monitored line is
idle.
To place a call to the monitored user when the IP phone is idle:
1.
Press the BLF key.
The IP phone dials out the phone number of the monitored user.
Transfer Mode on DSS Key is also applicable to BLF list feature.
Summary of Contents for SIP-T46S
Page 1: ...aji...
Page 26: ...User Guide for the SIP T46S IP Phone 16...
Page 230: ...User Guide for the SIP T46S IP Phone 220...
Page 235: ...Appendix 225 Appendix B Menu Structure...
