Enterprise IP Phone Getting Started
- 5 -
Note:
Using the wrong network parameters may result in inaccessibility of your phone and
may also have an impact on your network performance. Please contact your network
administrator.
Account Settings
The phone attempts to register to the SIP server using the account data provided by the
automatic or manual initialization.
Choose Account, you will find the following parameters:
Field
Description
Register Status
It shows the register status of the phone.
Account Active
You can choose on/off to enable/disable the account respectively.
Label
The name showing on the LCD of current device.
Display Name
The local phone name showing on the other phone when calling.
Register Name
Register name provided by ISP.
User Name
User account information, provided by ISP.
Password
Account password provided by ISP.
SIP Server
SIP server address provided by ISP.
When all accounts register fail, phone will display "No Service" by default.
When the phone reboot, it will register automatically. If many phones register at the
same time, this will affect the server, the users can set the register power up time so
that the phone will random register automatically within the set time.
Setting the power up time via web interface:
Choose Network->Advanced-> Registration random, enter the time in the field.
Note:
Should the IP PBX (SIP registrar) require an authentication, you will be prompted to
enter the correct password. Make sure you are using the appropriate input method or
enter the password via the web user interface.
Configuring via keypad
Network Settings:
Press MENU->Settings->Advanced, enter the password, and
choose Network->WAN Port/PC Port /VLAN/Web Type/802.1x Settings to enter the
internet relating configuration page.
Account Settings:
Press MENU->Settings->Advanced, enter the password, and
choose Accounts->OK to configure the account settings.
You can refer to the above “Configuring via Web Page” for the parameter detail.
