Configuring Advanced Features
237
Parameters
Permitted Values
Default
Description:
Enables or disables the CDP (Cisco Discovery Protocol) feature on the Skype for Business
phone.
0
-Disabled
1
-Enabled
Note:
If it is set to 1, the Skype for Business phone will attempt to determine its VLAN ID
through CDP.
If you change this parameter, the Skype for Business phone will reboot to
make the change take effect.
Web User Interface:
Network->Advanced->CDP->Active
Phone User Interface:
Menu->Advanced (default password: admin) ->Network->CDP->CDP Status
network.cdp.packet_interval
Integer from 1 to 3600
60
Description:
Configures the interval (in seconds) for the Skype for Business phone to send the CDP
(Cisco Discovery Protocol) request.
Note:
It works only if the value of the parameter “network.cdp.enable” is set to 1 (Enabled).
If you change this parameter, the Skype for Business phone will reboot to make the change
take effect.
Web User Interface:
Network->Advanced->CDP->Packet Interval (1~3600s)
Phone User Interface:
Menu->Advanced (default password: admin) ->Network->CDP->Packet Interval
To configure CDP via web user interface:
1.
Click on
Network
->
Advanced
.
2.
In the
CDP
block, select the desired value from the pull-down list of
Active
.
Summary of Contents for T46G Skype For Business Edition
