If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results.
In that case, you must manually add a wireless network:
>
Basic >Wi-Fi
1. Tap the Menu soft key
2. Tap the
On
radio box of the Wi-Fi field
3. The IP phone scans the available wireless networks in your area
4. Tap the
Add
soft key
5. Use the
WLAN
settings obtained from your gateway/router to configure this WLAN Profile on
your IP phone. Do the following:
a. If you select
None
or
WEP
from the pull-down list of
Security Mode:
Enter the profile
name, SSID and WPA shared key in the corresponding fields
b. If you select
WPA-PSK
or
WPA2-PSK
from the pull-down list of
Security Mode:
Select the
desired Cipher type (
TKIP, AES
or
TKIP AES
) from the pull-down list of
Cipher Type
Enter the profile name, SSID and WPA shared key in the corresponding fields
Yealink T48S Wireless Settings
Manually Add a Wireless Network
6. Tap the
Save
soft key to accept the change or
to cancel
Note:
The connected wireless networks will be saved to Known Network(s) list. The Known
Network(s) list can store up to 5 wireless networks, you can specify the priority to connect to
the corresponding wireless network
To view the wireless network information via phone user interface:
1. Tap the Menu soft key
>
Basic > Wi-Fi
2. Tap
after the desired wireless network to view the detailed wireless network information (e.g.,
Profile Name, SSID or Signal Strength)
Viewing the Wireless Network Information
Optus Loop –
Wireless Settings Yealink T48S
QRG
5
