| Phone Network |
13
Default
Blank
Web UI
Network
>
Basic
>
IPv4 Config
>
Configuration Type(Static IP)
>
Primary DNS
Or
Network
>
Basic
>
IPv4 Config
>
Configuration Type(DHCP)
>
Static
DNS(Enable)
>
Primary DNS
Phone UI
>
Settings
>
Device Settings
>
Network(Admin only, default password: admin)
>
WAN Port
>
IPv4 Type(Static IP)
>
Pri.DNS
Or >
Settings
>
Device Settings
>
Network(Admin only, default password:
admin)
>
WAN Port
>
IPv4 Type(DHCP)
>
IPv4 Static DNS(Enable)
>
Pri.DNS
Parameter
static.network.secondary_dns
[1]
<MAC>.cfg
Description
It configures the secondary IPv4 DNS server.
Example
:
static.network.secondary_dns = 202.101.103.54
Note
: It works only if “static.network.ip_address_mode” is set to 0 (IPv4)
or 2 (IPv4 & IPv6). In DHCP environment, you also need to make sure
“static.network.static_dns_enable" is set to 1 (On).
Permitted
Values
Secondary IPv4 DNS server address
Default
Blank
Web UI
Network
>
Basic
>
IPv4 Config
>
Configuration Type(Static IP)
>
Secondary DNS
Or
Network
>
Basic
>
IPv4 Config
>
Configuration Type(DHCP)
>
Static
DNS(Enable)
>
Secondary DNS
Phone UI
>
Settings
>
Device Settings
>
Network(Admin only, default password: admin)
>
WAN Port
>
IPv4 Type(Static IP)
>
Sec.DNS
Or >
Settings
>
Device Settings
>
Network(Admin only, default password:
admin)
>
WAN Port
>
IPv4 Type(DHCP)
>
IPv4 Static DNS(Enable)
>
Sec.DNS
[1]If you change this parameter, the phone will reboot to make the change take effect.
IPv6 Configuration
If you configure the network settings on the phone for an IPv6 network, you can set up an IP address for the phone
by using SLAAC (ICMPv6), DHCPv6 or by manually entering an IP address. Ensure that your network environment
supports IPv6. Contact your ISP for more information.
When you enable both SLAAC and DHCPv6 on the phone, the server can specify the phone to obtain the IPv6
address and other network settings either from SLAAC or from DHCPv6, if the SLAAC server is not working, the
phone will try to obtain the IPv6 address and other network settings via DHCPv6.
The following table lists the parameters you can use to configure IPv6.
Parameter
static.network.ipv6_internet_port.type
[1]
<MAC>.cfg
Description
It configures the Internet port type for IPv6.
Note
: It works only if “static.network.ip_address_mode” is set to 1 (IPv6) or 2 (IPv4 &
IPv6).
Summary of Contents for Teams Series
Page 1: ......
