| Phone Network |
28
Description
It configures the way the phone processes packets for the PC port when VLAN is
enabled on the PC port.
Note
: When packets are sent from the Internet port to the PC port, remove the
packet’s tag if it is same as the configured tag for the PC port, else forward the
packets directly. It is not to CP960 Phones.
Permitted Values
0
-when packets are sent from the PC port to the Internet port, the phone will forward
the packets directly.
1
-when packets are sent from the PC port to the Internet port, and there is no VLAN
tag in the packet, the phone will tag the packet with the configured tag for the PC port
and then forward it.
Default
1
[1]If you change this parameter, the phone will reboot to make the change take effect.
802.1x Authentication
Yealink Teams IP Phones support the following protocols for 802.1X authentication:
• EAP-MD5
• EAP-TLS (requires Device and CA certificates, requires no password)
• EAP-PEAP/MSCHAPv2 (requires CA certificates)
• EAP-TTLS/EAP-MSCHAPv2 (requires CA certificates)
• EAP-PEAP/GTC (requires CA certificates)
• EAP-TTLS/EAP-GTC (requires CA certificates)
• EAP-FAST (supports EAP In-Band provisioning, requires CA certificates if the provisioning method is
Authenticated Provisioning)
For more information on 802.1X authentication, refer to
.
•
802.1x Authentication Configuration
802.1x Authentication Configuration
The following table lists the parameters you can use to configure 802.1x authentication.
Parameter
static.network.802_1x.mode
[1]
<y0000000000xx>.cfg
Description
It configures the 802.1x authentication method.
Permitted Values
0
-EAP-None, 802.1x authentication is not required.
1
-EAP-MD5
2
-EAP-TLS
3
-EAP-PEAP/MSCHAPv2
4
-EAP-TTLS/EAP-MSCHAPv2
5
-EAP-PEAP/GTC
6
-EAP-TTLS/EAP-GTC
7
-EAP-FAST
Default
0
Summary of Contents for Teams Series
Page 1: ......
