| Registering the Handset |
22
Registering the Handset
You need to register your handset to the DECT manager (DM) if you want to use the basic functions of the
DECT multi-cell system.
•
Possible Reasons for Registration Failure
•
Registering the First Handset to the W80B Device
•
Registering More Handsets at the DECT Manager
•
Selecting a DM/Base Station to Connect
Possible Reasons for Registration Failure
Some scenarios may cause registration failure.
• Incorrect base PIN (check with your system administrator).
• Base station is out of range.
• Base station is not in registration mode.
Note:
If registration was not successful, the phone screen will prompt you that the registration is
failed.
Registering the First Handset to the W80B Device
You can register a handset to a W80B device to check the IP address of the DECT manager at the beginning
of system deployment.
Before you begin
• The W80B device role is
DM-Base
, and no handsets have been registered to the device.
• Long press the device key on the W80B till the DECT LED indicator flashes to set the device to the
registration mode. You can only register one handset to the W80B using this method.
Procedure
When the handset LCD screen prompts "Unregistered!", do one of the following:
• Press the
Reg
soft key on the handset to register quickly.
• Press
OK
>
Register Handset
and then select the desired base to register the handset.
You need to enter the base PIN (default: 0000) after a base is found.
After the handset is registered successfully, the handset LCD screen prompts “Handset Subscribed”.
Note:
If the handset LCD screen does not prompt “Unregistered!”, press the
OK
key to enter the
main menu, and select
Settings
>
Registration
>
Register Handset
to register the handset.
Registering More Handsets at the DECT Manager
After your system administrator has set the DM to the registration mode, you can register more handsets
to the DM.
