23
Horizon
/
Yealink W73P User Guide
Cascade Registration
Up to 2 repeaters can be registered to the base station in a cascade setup.
Before the cascade registration, you should first register the two repeaters to the base station. For
cascade registration, we recommend that you put the two cascaded repeaters closer to each
other. One repeater attempts to register to the other repeater (destination repeater).
If the destination repeater de-registers, the repeater does as well. Conversely, it does not.
The repeater supports automatic or manual cascade registration.
Auto Cascade Registration
1. Long press the program key on one repeater for about 3 seconds. The repeater starts
searching for the other repeater, POWER LED turns orange and DECT LED flashes
green.
Wait until POWER LED turns green and DECT LED turns green/orange, auto cascade registration
is successful.
Manual Cascade Registration
1. On one repeater:
a. Confirm the ID: Press the program key. The number of times that RELAY LED
flashes indicates the ID. Press the program key again to return to the operation
mode.
2. On the other repeater:
a. Long press the program key for about 3 seconds.
b. Press the program key as soon as POWER LED turns orange and DECT LED
flashes green, to enter the repeater's ID to be cascaded. Pressing once indicates
that the ID is 1.
POWER LED turns orange and DECT LED turns green.
c. Press the program key for about 3 seconds to confirm the ID.
The repeater starts searching for the repeater to be cascaded, POWER LED
turns green and DECT LED flashes orange.
Wait until POWER LED turns green and DECT LED turns green/orange, manual cascade
registration is successful.
ID Modification
If you want to register more than one repeater, in order to avoid ID conflict, we recommend that
you put the repeaters closer to the base station and register the repeaters one by one.
1.
Press the program key to confirm the ID.
2.
Long press the program key for around 7 seconds to enter the ID modification mode. When in
ID modification mode, both the Power and DECT LEDs turn red.
3.
Press the program key to enter the new ID. Pressing it once indicates that the ID is one, twice
means it is two etc. The number of times that the Relay LED flashes indicates the entered ID.
4.
Long press the program key for around 3 seconds to confirm the ID. The repeater will then re-
register.
