User Guide for the SIP-T41P IP Phone
114
answering the intercom call. If Intercom Tone is disabled, the phone will automatically
answer the intercom call without warning. Intercom Tone is enabled by default.
Intercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call
while there is already an active call on the phone. If Intercom Barge is enabled, the
phone will automatically answer the intercom call and place the active call on hold. If
Intercom Barge is disabled, the phone will handle an incoming intercom call like a
waiting call. Intercom Barge is disabled by default.
Note
To configure intercom features via phone user interface:
1.
Press Menu->Features->Intercom.
2.
Make the desired changes.
3.
Press the Save soft key to accept the change or the Back soft key to cancel.
These specific parameters are configurable via web user interface at the path
Features->Intercom.
To place an intercom call when the target phone is idle:
1.
Press the intercom key when the phone is idle.
The called destination plays a warning tone and automatically answers the call in
the speakerphone mode by default.
2.
To end the intercom call, press the intercom key again or the EndCall soft key.
You can use multicast paging to quickly and easily broadcast time sensitive
announcements to users who are listening to a specific multicast group. You can
configure a multicast paging key or the paging list key on the phone, which allows you
to send a Real Time Transport Protocol (RTP) stream to the pre-configured multicast
address(es) without involving SIP signaling. You can configure the phone to receive an
To enable the phone to receive a new incoming call when it has an active call, make sure
that call waiting feature is enabled on the phone in advance. For more information, refer
to
Call Waiting
on page
94
.
Summary of Contents for Yealink SIP-T41P
Page 1: ......
Page 22: ...User Guide for the SIP T41P IP Phone 10...
Page 160: ...User Guide for the SIP T41P IP Phone 148...
