MyPBX U300 Administrator Guide
16
Caller ID
The Caller ID will be used when this user calls another internal
extension.
Register Name
It is for extension registration validation. Users will not be able
register the extension if the authorization name is incorrect even
though the username and password are correct.
Voicemail
Enable Voicemail
Enable voicemail for the user.
Voicemail Access PIN
The voicemail password (digits only) for the user to access
the voicemail box.
Mail Settings
EnableSendVoicemail
Once enabled, the voicemailwillbe sent to a configured
email address.
Enable Send Voicemail
Wether to send voicemail to email or not.
Email Address
If
“Voicemail to Email” is enabled, fill in the email address
where to send the voicemail.
Note:
p
lease ensure that the section “SMTP Settings for
Voicemail”(in the “Voicemail Settings”) have been properly
configured before using this feature.
Pickup Group
If this extension belongs to a pickup group, any calls that ring
this extension can be picked up by other extensions in the same
pickup group by dialing the Call Pickup feature code (the default
is *4).
Note:
*4 is the default setting, it can be changed under
Feature
Codes→ General → Call Pickup
.
Max Call Duration
Setup the max cull duration for every call of this extension, but
it’s only valid for outbound calls. Enter “0” or leave this blank
empty, the value would be equal to the max call duration
configured in the Option Settings page.
Note:
this setting will not be valid for internal calls.
NAT
This setting should be used when the system is using a public IP
address to communicate with devices hidden behind a NAT
device (such as a broadband router). If you have one-way audio
problems, you usually have problems with your NAT
configuration or your firewall's support of SIP and/or RTP ports.
Qualify
Send check alive packets to IP phones.
Enable SRTP
Enable extension for SRTP (RTP Encryption).
Transport
This will be the transport method used by the extension. The
default is UDP.
DTMF Mode
RFC233, Info, Inband, Auto.
Remote Register
Allow to register remote extensions.
