MyPBX U300 Administrator Guide
94
Type.
Step2: Enter the IP Address.
Step3: Enter the Subnet Mask.
Step4: Enter the Gateway Address.
Step5: Enter the Primary DNS and Secondary DNS.
Step6:Save the changes.
Step7: Reboot the device.
Step8: Check the WAN Status (Status
Network status).
PPPOE
If your DSL provider saysthat you are connectingthrough
PPPoE or if younormally enter a user nameand password
to access theInternet, perform thesesteps:
Step1:
Select“PPPoE” as theWAN Connection Type.
Step2: Enter the User Name.
Step3: Enter the Password.
Step4:Save the changes.
Step5: Reboot the device.
Step6: Check the WAN Status (Status
Network status)
DHCP Server
Dynamic Host Configuration Protocol (DHCP) is a network protocol that enables a
server to automatically assign an IP address to a computer from a defined range of
numbers (i.e., a scope) configured for a given network. You can set a local network
NTP server for MyPBX here, too.
Note:
MyPBX U300 can work as a DHCP server, but cannot act as a router.
Figure 18-3 DHCP Server
VLAN Settings
VLAN (Virtual Local Area Network) is a group of hosts with a common set
ofrequirements, which communicate as if they were attached to the samebroadcast
domain, regardless of their physical location.
