N412 Administrator Manual
10
Static IP
Address
If your ISP says that you are connecting through a static or fixed IP
address, perform these steps:
Step1:
Select ―Static IP Address‖ as the WAN Connection Type.
Step2: Enter the IP Address.
Step3: Enter the Subnet Mask.
Step4: Enter the Gateway Address.
Step5: Enter the Primary DNS and Secondary DNS.
Step6: Save the changes.
Step7: Reboot the device.
Step8: Check the WAN Status (Status
Network status).
PPPOE
If your DSL provider says that you are connecting through PPPoE or
if you normally enter a user name and password to access the
Internet, perform these steps:
Step1: Select
―PPPoE‖ as the WAN Connection Type.
Step2: Enter the User Name.
Step3: Enter the Password.
Step4:Save the changes.
Step5: Reboot the device.
Step6: Check the WAN Status (Status
Network status).
Security Center
Users are strongly recommended to configure firewall and other security options
on N412 to prevent the attack fraud and the system failure or calls loss.
Security Center
All the security settings including Firewall, Service, Port Settings in N412 are
displayed in Security Center. Users could rapidly check and configure the relevant
security settings here.
Firewall
In the ―Firewall‖ tab, users could check firewall configuration and alert settings. By
clicking the relevant button, you can enter the configuration page directly.
Figure 4-3 Security Center
—Firewall
