TA410/810 User Manual
> Call Duration Settings
Table4-2 Description of FXO Port Call Duration Settings
Items
Description
Single Call Max Duration(min)
Configure the duration of each call, it’s 0 by default,
which means no limit.
Round up Duration
Once the value of Billing Unit is changed, the
“Round Up Duration” will be cleared, “Call
Duration” will also change accordingly.
Max. Call Duration(min)
Defines the maximum number of billing unit called
within a month through the trunk. To disable this
limitation set the value at 0.
Enable Clear Stat.
The date to clean the duration status each month.
Balance Alarm Settings
When
Max. Call Duration(min) is configured a 0 (no
limit), this feature is disabled.
Alarm threshold(min)
Cofigure the time duration when TA410/810 will
send the alarm message. The value must be less
than “Max Call Duration”.
Port
Choose the port to dial the alarm call.
Number
The number to receive the alarm call.
Prompt
The prompt played during the alarm call,you can
customize the prompts as your wish.
The email address to receive the alarm email.
Note: please make sure SMTP test is successful
in “Email settings” page before configuring this.
> Other Settings
Table4-3 Description of FXO Port Other Settings
Items
Description
Hangup
Detection
Hangup Type
Select which kind of hangup type will be used to
detect the call and hang up.
Busy Detection
Enable or disable Busy Detection. It is used for
detecting far end hangup or busy signal.
Busy Count
If Busy Detection is enabled, it is also possible to
specify how many busy tones to wait for before
hanging up. The default is 4, but better results
can be achieved if this setting is set as 6 or 8.
Higher value requires
more time for detection,
but lower the probability that a false detection
may occur.
Busy Interval
Set the busy detection interval.
Busy Pattern
If Busy Detection is enabled, you need to specify
35/55