NeoGate TG Series Installation Guide
14/16
Figure 4-2 NeoGate Admin Configuration Interface
Via the configuration interface, the admin can make all the system configurations, including
network settings (LAN, Firewall, VPN, DDNS, VLAN, etc.); system parameters configuration (time
zone, password, etc.); internal settings (Web access port, etc.); route lists; module lists; call logs
(search, download); firmware update and reset, etc.
Please note that after saving the changes, remember to click the “Apply Changes” button to
make the changes take effect.
4.3 Network Settings
After logging in the admin configuration interface, generally the first step is to configure the IP
address. If the LAN ports are connected to the network, their IP addresses need to be configured.
If not, just configuring the IP address of the LAN port which is connected to the local area
network of the company is OK.
‹
LAN Settings
Click “Network Preferences”->”LAN Settings” on the left menu bar of the web configuration
interface. LAN port is used for the interoperability of IP terminals and NeoGate. If the LAN
port is connected to the company’s LAN, please configure the correct IP address and
corresponding subnet mask.
Please note that after changing the IP address of LAN port, NeoGate should be rebooted to
make the new changes taking effect.
