STEP 3.1:
eCost DX10 Dongle Setup & eCost Software Configuration
The eCost Telephone Management software is accompanied by a DX10 Dongle hardware license.
DX10 Dongle
The D10 Dongle is used to authenticate the eCost software and required as part of the overall solution.
The driver installation process of the D10 Dongle is described below.
Driver installation Procedure
(1) Insert the hardware - DX10 Dongle into an available USB port on the customers PC.
Once you install the hardware, depending on the windows operating systems being used, an installing drive
detection window will appear in the bottom right corner.
Open the device manager from the control panel
You will notice, under
“Other Devices”
, USB Serial Port. Right click on the ‘USB Serial Port’, select properties.
The “USB port properties window is displayed. Select Driver Tab page