TB200/400 Installation Guide
10/11
4.2 Network Settings
After logging in the admin configuration interface, generally the first step is to
configure the IP address. If the LAN ports are connected to the network, their IP
addresses need to be configured. If not, just configuring the IP address of the LAN
port which is connected to the local area network of the company is OK.
LAN Settings
Click “Network Preferences”-> “LAN Settings” on the left menu bar of the web
configuration interface. LAN port is used for the interoperability of IP terminals
and the device. If the LAN port is connected to the company’s LAN, please
configure the correct IP address and corresponding subnet mask.
Please note that after changing the IP address of LAN port, TB200/400 should be
rebooted to make the new changes to take effect.
4.3 Make and Receive Calls
1. Calls from BRI to SIP
Users should be able to receive BRI-to-SIP call after configuring a route on
TB200/400 and an inbound route on SIP server if needed. Please refer to
Yeastar TB
BRI VoIP Gateways User Manual
for details.
2. Calls from SIP to BRI
Users should be able to make SIP-to-BRIcall after configuring a route on TB200/400
and an outbound route on SIP Server. Please refer to
Yeastar TB BRI VoIP Gateways
User Manual
for details.
4.4 Reset to Factory Defaults
To reset to factory defaults, you could follow the below instruction:
Press the “RESET” button located in the back panel with a paper clip or a pencil tip.
You can see the RUN indicator stops flicker and turns solid. When the RUN indicator
turns off, the button could be released and system begins to reset. During the process,
please do not power off until the RUN indicator become normal which means the reset
process is completed.
Note: after resetting, all the configurations made by the admin would be erased.
