TG Series User Guide
45/104
3.
Check the status of the two peer trunks on both your PBX and the TG gateway.
If the status of the two peer trunks both indicate connected, then the TG gateway and your PBX
are connected.
Set up a Mobile to IP Route (Peer Trunk Mode)
Procedure
7.
Navigate to
Gateway > Routes Settings > Mobile to IP
.
2.
Click
Add Mobile to IP Route
.
3.
Enter a name in the
Route Name
field.
4.
Choose a GSM/3G/4G trunk or a trunk group from
Call Source
field.
5.
Choose a service provider trunk from the
Call Destination
field.
6.
(Optional)
Set the
Hotline
number.
If you set hotline to a PBX extension number, the incoming call will be routed to the
extension directly.
If you set the hotline to the DID number of PBX’s inbound route, the call will be routed to the
destination of the inbound route.
Note: if you don’t set a hotline number, you will need a two-stage dial to reach the destination
number.
Summary of Contents for TG400G
Page 23: ...TG Series User Guide 23 104 ...
Page 104: ...TG Series User Guide 104 104 ...
