NeoGate TE200 User Manual
22/42
Warning
:
Rebooting the system will terminate all active calls!
·Reset to Factory Defaults
Warning
: A factory reset will erase all configuration data on the system.
Please do not turn off the system until the RUN light begins blinking. Any power
interruption during this time could cause damage to the system.
5.3.5 Firmware Update
Upgrading of the firmware is possible through the Administrator web interface
using a TFTP Server or an HTTP URL.
Enter your TFTP Server IP address and firmware file location, then click start to
update the firmware
Note:
1. If enabled "Reset configuration to Factory Defaults", the system will restore
to factory default settings.
2. When updating the firmware, please don’t turn off the power. Or the system
will get damaged.
3. For more information about the steps to update the firmware, please refer to
this link:
http://www.yeastar.com/download/NeoGate_TE200_FirmwareUpgrade_en.pdf
Figure 5-15
6. Gateway
6.1 Digital Trunk
On this page we can configure the details of E1 trunk, before configure anything,
please make sure the cable is fine, and you have got enough information from
the ISDN provider.