Yeelight Sunflower
User manual (English)
2
/
3
Copyright © yeelight.com 2012-2014
Ver: SF-1
After you install all the components and system is running, a wireless binding between the bulb and control box
is created. In this manual, there are also operations for you to unbind them.
1.
Preparation
1)
There is a home Wi-Fi AP and your smart phone can connect to it;
2)
Check the accessories, including LAN cable, an USB power cable and an USB power adapter.
2.
Starter pack
1)
Plug LAN cable into LAN interface of your Wi-Fi AP, and plug another end into control box;
2)
Plug in the power cable.
The LAN indicator on control box will fast flash for several times during network configuration, then slow flash for
several times during booting. When it boots up, the LAN indicator is always on. During your control from smart
phone, it will flash 3 times when it gets a command.
3)
Screw the bulb into mount base, then turn on the power.
When bulb is turned on, and it transmits messages with control box, the wireless indicator on control box will
show on.
3.
Extra bulb via single pack
Screw the bulb into mount base, then turn on the power. Refresh the list on smart phone, it will show new
discovered bulbs.
If you have problems when install extra bulbs, especially when you get them from other control, try to restore
bulb to factory setting, or put them closer to control box to get better wireless signal. About restoring to factory
setting, see the operation in
advanced operation
section.
4.
Advanced operation
1)
Restore control box to factory setting
Press down the button on control box and hold it for 10 seconds, then release it, both the LAN indicator and
wireless indicator will fast flash for about 3 seconds. When all the 2 indicator LEDs shows on, the operation is done.
The restore operation will clean the bind info on control box, so the bulb list will be swept, you should reinstall
them. If the bulb is online when you do this operation, it also be restored to factory setting.
2)
Restore bulb to factory setting
Keep your bulb on for at least 30s, then turn it off, now you can do the restore operation as following steps:
i)
Turn bulb on, when it’s up and shows maximum white light, turn off immediately (less than 5 seconds);
ii)
Repeat above step for 3 times;
iii)
Then turn on the bulb again, you could see bulb shows red/green/blue/white, it means the
Installation
