9
Curtain opening direction
Rotate the snap of the curtain bracket to the maximum position, insert the non-snap
side of the automatic curtain opener into the track and rotate 90°, take the roller as the
center, and pull down the non-snap side, make the non-snap side reach the maximum
length, insert the adapter wheel on the snap side into the curtain track, rotate the snap
to return and clamp it, push the curtain to move left and right, if the curtain runs
smoothly, the installation is complete.
Han the curtains back to hide the automatic curtain opener.
When using dual tracks, please install it back-to-back, and the distance between the
track is greater than 22mm.
Double panel curtains (requires two automatic curtain opener)
Refer to the installation method of single panel curtain, hang the two curtain motors
between the first and second hooks of the curtains on the left and right side
respectively. If the curtain cannot fully close after calibration, please install the curtain
motor between the second and third hooks (as shown in the figure), then please try to
calibrate it again.
