LC
Singlemode
ST
Singlemode
SC
Singlemode
LC
Multimode
Connections
The SDI video outputs are connected to the corresponding 75 Ohm BNC
connections provided. The fiber connection is made to the fiber SFP sub module
as indicated on the module.
Four versions of the module are available, the only dierence is the SFP sub module
installed into the basic module.
ORX 1802-2 LC
- Singlemode LC ber connection
ORX 1802 ST
- Singlemode ST ber connection
ORX 1802 SC
- Singlemode SC ber connection
ORX 1802 MM
- Multimode LC ber connection
Operation
Operation of the ORX 1802 is fully automatic. The SDI video format is automatically
detected, reclocked and provided on two SDI output connections. The module
supports all SDI video standards as well as DVB/ASI.
The ORX 1802 supports hot swapping and hot plugging of
connections.
No user settings are provided for this module.
The module fiber connection is supplied with a rubber plug installed, this is to
prevent dust contamination. Please retain the plug and use if the cable is ever
disconnected from the module.
Power
The module requires a 12V DC power input and the LED confirms when power
is connected. A power supply is provided, however if you use your own power
supply, please provide a clean power source between 7 and 24VDC.
The OTX 1410 has a power consumption of approximately 2.2W nominal.
