3
“
nod.1
”
and then press
“
enter
”
to work the machine(If the main lighting is set,
read DMX will be on.) If in-phase working is to be set, the subordinate lighting
must displaying the address codes. (If the machine is not connected to DMX
controller, the display screen will glisten, otherwise, it will not glisten. And the
DMX signal indication light will glisten due to availability of signals. If
“
on
”
is
chosen, disconnect DMX controller. Only one light can be set to be the main
light.) The DMX address set of the subordinate light will not change. e.g. The
address code of the subordinate light can be
“
001
”
or other figures.
RPAN(PAN inverse) . This enables pan inverse.
Press
“
up
”
or
“
down
”
to indicate
“
rpan
”
. Choose
“
on
”
to enable pan inverse.
Press
“
enter
”
to confirm and store the setting and then exit.
rtilt(tilt inverse). This enables tilt inverse.
Press
“
up
”
or
“
down
”
to indicate
“
rtilt
”
. Choose
“
on
”
to enable tilt inverse.
Press
“
enter
”
to confirm and store the setting and then exit.
Working mode:
Press
“
down
”
or
“
up
”
to show
“
dn.pr
”
. Then press
“
enter
”
to show
“
nod.1
”
or
“
nod.2
”
. Then press
“
enter
”
to finish the setting.
“
nod.1
”
and
“
nod.2
”
are the
two working modes.(
“
nod.1
”
is for the control with channels of regualr number
and
“
nod.2
”
is for the control of fewer channels.)
We reserve right to change the manual without further notice.
