iXm Getting Started.
Yellowtec 10-2009.
Page 1 of 6
Congratulations to iXm, the powerful and easy to use reporter microphone with built-in
recorder. Before you start recording for the first time, you will need to charge the internal Li-
Ion accumulator battery to 100% capacity and to insert the SD card.
Preparation
Charging iXm
Connect the device to a USB-Port of your PC or an USB-Charger by plugging-in the USB
cable. iXm will indicate the charging process by a slowly yellow blinking BAT indicator. The
device need not be switched on.
When the BAT indicator stops blinking, the internal Li-Ion accumulator battery is full.
SD Memory Card
Insert the SD memory card into the device as shown on the picture below. Push it to the
bottom and release it. The card shall snap in.
If you want to remove the card, press it down again to release it.
Getting Started
