Page 2 of 47
25.12.2018
DIS-14-ek
Rev Nr: 2
READ THIS HANDBOOK BEFORE INSTALLING YENEN LPG DISPENSERS
Dispensers are powered by electrical energy and contain dangerous, inflammable and potentially
explosive liquid. Failure to observe the precautions and warning instructions given in this handbook may
cause serious accidents. Observe all rules, codes and laws applicable in your area and your installation.
SAFETY PRECAUTIONS
– INSTALLATION AND MAINTENANCE
ALWAYS disconnect the power supply before opening dispenser cabinet for maintenance. Ensure that the
valves under the dispenser are closed BEFORE commencing maintenance.
Make sure that you know how to disconnect power input to the dispenser and pump, in case of an
emergency. Have all leaks and faults repaired immediately.
Contact Yenen
Any problem relevant to the installation and operation of the Dispenser should be notified to an authorized
Yenen Service Partner or Yenen Technical Support Department. (+90 216 487 5924).
Explanation of Symbols
Notice: indicates a special comment or instruction.
Warning: Indicates a hazard, which may cause serious personal injury damage to
property if not observed cautiously.
This handbook provides instructions and rules. Remarks and warnings inform the operator about the
dangers relevant to the installation and operation of LPG Dispensers. Reading these instructions and thus
preventing possible dangerous events is absolutely in the operator’s power. Any omission of this
responsibility is beyond Yenen’s control.
No part of Yenen
handbooks may be reproduced, issued, copied and changed in any way and form without Yenen’s prior
written consent.
Yenen reserves the right to change the specifications of the products mentioned in this handbook at any time and without prior
notice.
Yenen may not be held liable for any damage arising from the use of this product.
Although every effort to make sure that the information in this handbook has been made, Yenen may not be held responsible
for any error in the content or incidental and consequential damages resulting from the use of this handbook
Yenen Engineering logo(s) are property of Yenen Engineering..
Yenen Engineering is ISO9001:2008 certified. If you request a copy of Yenen Quality Policy and/or Yenen HSE Policy, please,
visit
or send an e-mail to
or fax your request to +90 (216) 487 5986.
