Yeong Yang YY-R226 Technical Instruction Download

Page: 2 / 4

ZZ17-21002-A 3

2.3. Power Supply Installation

PS2 power supply:

Screw the power supply holder

onto chassis.

Plug the AC inlet adaptor cable

to the AC socket. Then tighten

power supply with brackets and

screws.

Screw the external AC switch

in rear end of chassis, then

plug in the AC inlet cable.

This PS2 power supply could

be changed as a DC to DC

PSU

ZZ17-21002-A

2.4. 3.5” & 5.25” devices

assembly

Loosen (4) screws, lift up 3.5” &

5.25” driver bracket.

Remove the metal covers.

Install FDD & CD-Rom, mount

driver bracket into chassis.

Summary of Contents for YY-R226

Page 1: ...S2 PSU ATX 250 400W DC to DC Riser Card various connectors i e PCI AGP Rear Window 3 slots PCI Slide kits 20 telescopic slides are suggested ZZ17 21002 A 2 II System Assembly and Disassembly 1 Control...

Page 2: ...tighten power supply with brackets and screws Screw the external AC switch in rear end of chassis then plug in the AC inlet cable This PS2 power supply could be changed as a DC to DC PSU ZZ17 21002 A...

Page 3: ...lation To assemble riser card into riser card holder To slot in add on cards into riser card and screw in bracket To slot in daughter board of riser card into 5th PCI slot Before slot in the holder se...

Page 4: ...ected into motherboard or connect to power supply through an connector changer Flat cables suggested to be route well by cable tie and cable clip 2 8 Close top cover Close the top cover with 4 screws...