11
6.6 Channel Buttons(
▼
,
▲
)
Channel Buttons(
▼
,
▲
) have 3 functions as shown in following.
①
Channel buttons(
▼
,
▲
) are to change channels.
②
Channel buttons(
▼
,
▲
) are to select menu at menu mode.
③
Menu(p) + Channel up(
▲
) are to Channel Lock, Menu(p) + Channel down(
▼
) are to Channel
unlock
6.7 Accessory Connector
The Accessory Connector is used when using an external speaker microphone or doing PC
programming or making the Cloning or using as a Repeater.
6.8 LED Status
The LED indicates various status' of the radio.
(1) RX - Green color
(2) TX - Red color during PTT
(3) CTCSS, DCS Error - Green color blinking
(4) Low Battery - Red color blinking with beep tone
6.7 Function Operation
Enter into Menu mode by pressing the Menu button (P) for 2 seconds.
The sequence of menu mode is as follows.
6.8 CTCSS/DCS/DCS Inverter sub-tone channel selection:
Press Menu (P) button for more than 1 second and the radio will go into function setting mode.
Press UP (
▲
) or DOWN (
▼
) button to select Type of Sub-Channel.
CTCSS Sub-Channel : (
)
DCS Sub-Channel : (
)
DCS Inverter Sub-Channel : (
▬
)
No setting Sub-Channel : (0)
To select CTCSS tone sub-channel, select ( ) by pressing UP (
▲
) or DOWN (
▼
) button, and
press Enter (
) button.
Summary of Contents for XV-100A
