YEONHWA M TECH XV-100A, Service Manual

12

Sub-Tone channel LCD digit will be blinking 

Press Up or DOWN to select your desired channel (1~38), and press Enter ( ) button to 

confirm it. 

To exit from menu, press M button or PTT switch. 

Use same method to set up DCS ( ) or DCS Invertor ( ) Sub-Tone Channels 

6.8.1 VOX Function On/Off selection: 

Press Menu (P) button for more than 1 second and the radio will enter into function setting mode. 

Press Menu (P) button again. Then VOX setting Icons will be blinking. 

By pressing UP (

▲

) or DOWN (

▼

) button, you can select on or off. To exit from menu, press M 

button or PTT switch.

6.8.2 Scan On/Off selection: 

Press Menu (P) button for more than 1 second and the radio will enter into function setting mode. 

Press Menu (P) button 2 times. Radio will go to Scan setting menu mode. 

By pressing UP (

▲

) or DOWN (

▼

) button, you can select On or Off. 

Select on and press Enter ( ) button to confirm Scan On. To exit from menu, Press M button or PTT 

switch 

If you want to enable Scan function, Press Menu (P) + Enter ( ) at the same time. 

Then radio will begin scan. To stop Scan, press Menu (P) button. 

( With programming software, a more selective type of scan method can be chosen.) 

6.8.3 Beep Tone On/Off selection: 

Press Menu (P) button for more than 1 second and the radio will enter into function setting mode. 

Press Menu (P) button 3 times. Radio will go to Beep tone on/off setup mode.