YES Watch Zulu series, Instruction Manual

Basic Button Functions

M - The Mode button is used to cycle through these modes: 

SHOWING TIME (for HOME / AWAY locations) 

SET HOME > SET AWAY > SET TIME 

SETLCD RING > STOPWATCH > TIMER 

S/M CALC > PET COUNTDOWN

S - The Set & Data review button is used to enter selected mode and to set data. In normal running mode it is

used to review time data and toggle between HOME / AWAY locations.

L - The Lock & Alarm button is used to lock settings, enter and activate the alarm, override DST settings

manually and other time data review functions.

B - The Backlight button is used to turn the light on, turn the Digital time off and step backwards during setting

sequence.

C - The Crown is used to set the 24-hour solunar hand.

Please note that for the watch to operate correctly

location and time must be set.

How to set

HOME and AWAY locations

The watch is pre-programmed for 583 locations worldwide

through the years 2000 - 2099.

The city listing is in alphabetical order.

- Push M once until display reads SET HOME, then push S to enter the alphabetical setting sequence. The letter

A will flash.

- Push S until you reach the first letter of your city, then push L to enter the city listing. Continue pushing S until

your city appears. (If you pass your selection, push B to go backwards.) Then push L to lock the selection. The

display will read WAIT and then it will display location and time.

- To set your AWAY location push M twice until display reads SET AWAY and then follow the same procedure

as above.

- To toggle back and forth between time for HOME and AWAY locations, push S twice, quickly.

Pushing M anytime during setting procedures,

or pushing no button at all for 2 minutes,

will revert the watch to previous setting.

How to Set location by latitude

and longitude