Short Form Installation Guide
Wiring
25
4.2.6.
Example of Connections for Three-phase 200V XtraDrive
*1. P represents twisted-pair wires
*2. The time constant for the primary filter is 47us.
*3. Connect only with an absolute encoder.
*7. These circuits are SELV circuits, therefore are
separated from all other circuits by double and
reinforced insulator.
*4. Used only with an absolute encoder.
*8. Use a double-insulated 24-VDC power supply.
*9. Optional – not available in all models.
*5. Connect an external regenerative resistor between
terminals B1 and B2.(for XtraDrives with big capacity)
*10. Resistors are different for each model.
*6. These circuits are hazardous, therefore are separated
by protecting separator.
*11.
∅
Represents contacts of CN1 connector
Summary of Contents for XtraDrive XD Series
Page 2: ...Short Form Installation Guide Introduction 2...
Page 9: ...Short Form Installation Guide Introduction 9 1 2 Warning Label...
Page 24: ...Short Form Installation Guide Wiring 24 4 2 5 Three phase 200V Main Circuit...
Page 26: ...Short Form Installation Guide Wiring 26 4 2 7 Three phase 400V Main Circuit...