24.
25.
tighten a collet bolt assembly into the non drive
side of the main pivot collet axle with a 5mm
allen key.
torque to 155-160 in/lb
press two 22mm Fox reducers into the the lower
shock eyelet. tap the reducers into place with a
dead blow hammer if necessary.
install the shock onto the frame. insert a 34mm
ti female bolt with washer through the drive
side of the frame and shock. Use a ti male bolt
prepped with blue loctite on the non-drive side
and tighten with two 5mm allen keys.
repeat the process for the shock and upper link
interface. Use the fox guide pin tool and a dead
blow hammer to help guide any female ti bolts
through the frame and frame components.
torque both bolts to 90-95 in/lb.
13.
14.
15.
16.
Grease the shaft and threads of the upper link
collet axle. insert the collet axle through the
swingarm and the upper link bearings from the
non drive side of the frame and tighten with a
10mm allen key.
torque to 35-40 in/lb.
tighten a collet bolt assembly into the non drive
side of the upper link collet axle with a 5mm allen
key.
torque to 155-160 in/lb.
18.
17.
assembly
assembly
