Yeti 160E, Owner'S Manual

YETI 160E  |  OWNER’S MANUAL

10

FRAME ASSEMBLY

TABLE OF CONTENTS  |

05

Lightly grease the bore and collet nut interface 
on the Front Triangle main pivot interface Install 
Lower Switch Link Assembly (4.1) with two Race 
Extenders (4.15) into the Front Triangle and secure 
with 15mm Collet Axle (4.8) and Chain guide 
Mount Collet Nut (4.47). 

Torque to 20-25 Nm

10

Install Switch Link Fender (4.38) to the Front 
Triangle using 2X FHCS (4.20) Torque to 2.5 Nm or 
until snug.

07

Install 2x Bearing Reducer, Large Flange (4.17) 
and 2x Bearing Reducer, Small Flange (4.16) to the 
outides and insides of the Rocker Link Assembly 
rear bearings. 

Repeat for seatstay Clevis interface.

06

Lightly grease bore and collet nut interface of 
chainstay main pivot interface. Install remaining 
15mm Race Extenders (4.15) onto Lower Link (4.1) 
and place chainstay onto Link. Secure with 15mm 
Collet Axle (4.8) and Cable Clamp Collet Nut (4.58). 

Torque to 20-25 Nm

11

Tighten non-drive side Rocker Link pinch bolt 
and torque to 5-6 Nm Torque the 2X M4 FHCS 
securing the Rocker Links and Bridge to 5 Nm.

Note: This bolt must be loosened prior to link 
removal.

08

Install seatstay onto frame, aligning first at the 
Rocker Link Assembly. Use 12mm guide pin to 
align and secure with 2X Clevis Bolt (4.14). Align 
the chainstay and seatstay clevis interface using 
12mm Guide Pin and secure with 2X Clevis Bolt 
(4.14). 

Torque all clevis bolts to 12 Nm

09

Install Cable Port Cover, Single (4.27) to the inside of the chainstay non-drive side surface and secure 
lightly with M4 FHCS (4.20). 

Repeat installation of port cover on Front Triangle non-drive side.