YETI 160E | OWNER’S MANUAL
13
E-COMPONENT ASSEMBLY
TABLE OF CONTENTS |
09
Install Base, Housing Clamp (4.53) underneath
brake housing and sensor wire and secure with
Clamp, Housing Clamp (4.54) and M3 FHCS
(4.33).
Tighten hand-tight.
11
If assembling a non-wireless seatpost kit, route
length of dropper/shifter housing starting at the
drive-side Lower Cable Port. Clip housing into
Management Trays in the first or second-position
from drive-side. Pass the housing on either side of
the battery mount insert, into the motor cavity, and up
the seattube. Ensure adequate length from head tube
and out of seat tube to ensure setup compatibility.
10
Clamp shifter housing and sensor wire to
the rear Main Pivot Collet Nut (4.57) and secure
with Housing Clamp (4.56) and M3 SHCS (4.55).
Tighten hand-tight.
12
Route a 1200 mm Shimano E-wire down the
downtube. Insert into drive-side Upper cable port
and route down downtube securing in one of the
small E-wire channels. Route wire through non-
drive side pass-through past battery mount.
Leave approx. 6-8” of wire exposed from headtube
port exit.
13
Route a 1200 mm Shimano E-wire down the
downtube. Insert into drive-side upper cable
port and route down downtube securing in one
of the small E-wire channels. Route wire through
non-drive sides pass-through past battery mount.
Leave approx. 6-8” of wire exposed from
headtube port exit.
14
Install the Satellite Power Switch (4.6.6) into the top of
the Top Tube. Tuck front lip of switch in before placing
flush. Secure with provided Shimano screw (4.6.5).
Tighten hand-tight (Shimano spec: 0.6 Nm) Route
switch wire down downtube securing in the remaining
E-wire channel. Route through non-drive side pass-
through past the battery mount.
15
Route the Satellite Charge Port harness (square
plug) out the hole in the frame non-drive side and
attach the Satellite Charge Port (4.6.3) outside of
the frame.
16
Attach the main power cable harness (circular plug)
into the motor. Pay attention to the keying by aligning
the arrow on the harness clip to the motor receptacle.
ALL BATTERY MOUNT ADJUSTMENTS SHOULD BE PERFORMED BY AUTHORIZED YETI
CYCLES DEALER. DO NOT ATTEMPT TO ADJUST ANY OF THE HARDWARE RELATED
BATTERY MOUNT.
Summary of Contents for 160E
Page 1: ...YETI 160E OWNER S MANUAL...
