Yeti 160E, Owner'S Manual

YETI 160E  |  OWNER’S MANUAL

15

E-COMPONENT ASSEMBLY

TABLE OF CONTENTS  |

27

Install OnesUp O-Ring onto the Chainguide Mount 
Shoulder Bolt (4.50). Secure OneUp Components

Chainguide (outer and inner, 4.51 and 4.52) with 
Shoulder Bolt (4.50) onto the Chainguide Mount 
Collet Nut (4.47).

28

Install Housing Clamp, Chainguide Mount (4.48) 
around shifter housing (if applicable) and onto the 
Chainguide Mount Collet Nut (4.47) using 1x M3 
FHCS (4.49). Tighten until snug. If overtightened, 
shifting performance can be effected.

29

Install Cable Clamp, chainstay Collet Nut (4.57) 
onto the Collet Nut, Housing Clamp (4.58) by 
inserting the small tab under the collet nut 
overhang. Secure with M3 x 10L Cap Screw 
(4.56). Tighten screw until snug around housing, 
or hand-tight if assembling a wireless drivetrain kit. 
If overtightened, shifting performance can  
be effected.

32

Install Shimano Chainring onto Motor and secure 
with chainring Lockring. Note that Lockring is 
LEFT HAND thread. Torque to 35-45 Nm using 
crow’s foot attachment. Ensure chainring sits in 
between chainguide halves.

31

Install a Shift + E Cable Port Cover (4.24) or E-Only 
Cable Port Cover (4.25) (kit-dependent) with a Cable 
Port Cove Base (4.22) onto the drive-side headtube 
and secure with M4 FHCS (4.19). Tighten until snug. 
Install a Shift + Brake Cable Port Cover (4.23) or 
Brake-Only Cable Port Cover (4.26) (kit-dependent) 
with a Cable Port Cover Base (4.22) onto the non-
drive side headtube and secure with M4 FHCS 
(4.19). Tighten until snug.

30

Install Base, Housing Clamp, chainstay Collet 
Head (4.54) and Clamp, Housing Clamp, chainstay 
Collet Head (4.55) into the non-drive side collet 
head in the chainstay with a M3 x 25L FHCS (4.33). 
Ensure that brake line and speed sensor wire have 
adequate strain relief to the front triangle and not 
being pulled, tugged, or bent throughout travel. 
Tighten clamp around Speed Sensor wire and 
brake housing until snug (hand-tight).

33

Install Shimano cranks per manufacturer 
instructions. Install crankarm cap and tighten to 
0.7 - 1.5 Nm. Torque 2X Crank Arm pinch bolts to 
12-14 Nm

25

Install Battery (4.6.2) into the downtube. Battery 
should clip in firmly and latch without pinching any 
wires or housing. Install Battery Guard (4.7) onto 
the Battery using 4x M4 BHCS (4.63). Snug the 4x 
BHCS until hand-tight.

26

Install Battery Guard (4.7) onto the Battery using 4x  
M4 BHCS (4.63). Snug the 4x BHCS until hand-tight.