Yeti 160E, Owner'S Manual

YETI 160E  |  OWNER’S MANUAL

16

E-COMPONENT ASSEMBLY

TABLE OF CONTENTS  |

01

-    Insert the mode switch wire (Orange) in the hole in the left side of the handlebar and push until it exits the 

left side of the bar end.

-    Using an internal cable routing tool (Yellow), insert the tool into the hole near the center of the handlebar 

and push through until it exits the left side bar end.

-    Connect the mode switch wire (Orange) to the internal cable routing tool (Yellow) and pull the internal 

cable routing tool back through the hole at the center of the handlebar.

03

-    Install the Shimano cycle computer onto the handlebar, directly to the right of the stem. Use a 3mm hex 

wrench to tighten the clamp bolt to 0.8Nm (7.1 in-lb).

-    The wire from the mode switch routes through the handlebar and connects into the left port of the cycle 

computer. After connecting the mode switch wire, tuck the excess wire back into the handlebar.

02

-    Install the mode switch in the correct location next to the grip on the rider’s left side of the handlebar. 

Take care to ensure the mode switch wire is aligned in the groove under the bar and passes under the 
clamp before connecting to the mode switch. Use a 3mm hex wrench to tighten the mode switch clamp 
bolt to 1.5Nm (13.8 in-lb). Ensure that the mode switch wire is seated in the groove when installing the 
grip to avoid damaging the wire.

HANDLEBAR WIRING