Unit 1 Westfield Court | Barns Ground | Clevedon | Bristol | BS21 6FQ | UK
Tel No: +44 1275 217060 | Email: support@yetitool.com
SMARTBENCH V1.1
9
Fit the Z Head
To Fit the Z Head, offer up the Z head ensuring
the extraction elbow is facing towards you.
Load the Z head by inserting the wheels into
the channels until the Z head holds onto the
beam. This should be just passed the first
wheel.
Place the drag chain latch plate over the
protruding face on the side of the Z Head
bottom plate ensuring the signal cable seats
into the recess.
Secure this in place with the thrubmscrew
provided.
Plug in the signal cable and secrure with the
thumbscrew.
Place the drag chain latch plate over the
protruding face on the side of the Z Head.
1
2
3
4
5
6
Summary of Contents for SMARTBENCH V1.1
Page 1: ...Quick Start Guide...