Call:
+44 (0)1268 570900
Fax:
+44 (0)1268 732509
Email:
enquiries@yewdale.co.uk
Visit:
www.yewdale.co.uk
7
b) Remove the template and drill an 8mm hole.
c) Place the punch into position and tighten the bolt, ensuring the punch is
held square at all times.
N.B It is critical that this is punched squarely in the correct position.
12
.
To drill the holes for the safety screws at either end of the head box cover,
use the template provided. Mark the hole shown below with a pencil. When
marked, remove the template and drill a 4mm hole and countersink.
13
.
Attach the chain guide to the transition plate by threading the chain
through the chain guide and then by using 2 chain guide screws (940006)
attach this to the transition plate.
14
.
Attach the head box cover onto the head box, close and secure closed using
the 2 safety screws (933010).
15
.
Lift the head box onto a test rig and ensure the blind operates correctly.
16
.
To transport the blind, it is recommended that the barrel with the fabric is
removed from the head box and packaged separately.
Ensure the relevant child safety device is used to comply with BS
EN13120:2009+A1:2014, BS EN16433:2014 and BS EN16434:2014.
Use this
hole on the
template
