Call:
+44 (0)1268 570900
Fax:
+44 (0)1268 732509
Email:
enquiries@yewdale.co.uk
Visit:
www.yewdale.co.uk
5
1
.
Ensuring the head box/fascia profile is square within the saw, cut the head
box to size.
2
.
Ensuring the head box cover is square within the saw, cut the cover to size
making sure there is no distortion.
N.B It is critical that the profile is cut square to enable the cover to close.
3
.
Cut the barrel, bottom bar, side channels, fabric insert, and fabric and drill a
14mm hole in either the back or top of the head box containing the motor to
allow the motor cable to exit (the location of the hole will need to be at the
fitter’s discretion).
4
.
File all aluminium cuts and cut a small V-shape in the top of the PVC tracker
profile to assist in fabric location.
5
.
Weld a small pocket at the bottom of the fabric. Weld zip onto fabric both
sides of the fabric to match the drop of the blind. Cut off any excess zip.
6
.
At the top of the fabric, attach part 962499 (10mm plastic strip with double
sided tape) and staple it to the fabric.
7
.
Attach fabric to barrel sleeve and bottom bar making it central on the
918252 barrel sleeve. Use double sided tape to fix the fabric in place on the
barrel. This barrel sleeve can now be slid over the top of the smaller barrel.
8
.
Drill a hole in the bottom bar, 10mm centred from the edge of the bottom
bar. This needs to be on the bottom edge where the pile seal is located.
9
.
With a 3mm drill bit, drill a hole in the face of the bottom bar. This needs to
line up with the centre of the hole, on the underside of the bottom bar, and
in line with the groove on the edge of the bottom bar (see image below).
C57-90/120T Cassetted Blinds:
