YewdaleDefiant
®
Manufacturing instructions
Part no: 1062
6
Manufacturing Instructions
YewdaleDefiant
®
cassetted blinds (C57-90/120T)
10
.
Make a small incision in the welded pocket in order to slide in the fabric
insert. Attach the bottom bar to the fabric using the fabric insert. Once
complete insert the end caps.
11
.
Insert the transition plates into the head and attach the end plates using
933010 screws.
12
.
Attach the motor adaptor set 980012 to the motor.
13
.
Insert the motor into the barrel making sure the grooves are aligned with
the adaptors and then insert the pin end 918246 into the barrel.
14
.
Threading the cable through the 12mm hole, place barrel and fabric into the
head box by locating the pin end first into the transition plate.
15
.
To drill the holes for the safety screws at either end of the head box cover,
use the template provided. Mark the hole shown below with a pencil. When
marked, remove the template and drill a 4mm hole and countersink.
16
.
Attach head box cover onto the head box, close and secure using the two
safety screws (933010).
17
.
Lift head box onto test rig and ensure blind operates correctly.
18
.
To transport blind, it is recommended that the barrel with fabric is removed
from the head box and packaged separately.
Use this
hole for 90
head box
Use this
hole for 120
head box
