Call:
+44 (0)1268 570900
Fax:
+44 (0)1268 732509
Email:
enquiries@yewdale.co.uk
Visit:
www.yewdale.co.uk
7
R20C Crank control:
1
.
Complete the R20 Slipstream process missing out points 5 and 6.
NB. The R20C is only available on the 45mm barrel (Part number 938027) then:
2
.
Insert end plug with square pin (Part number 911769) into the 45mm barrel
(Part number 938027)
3
.
Fasten the gear box (Part number 70401) to the control bracket (Part
number 9330135W) using the nut and bolt (Part number 813) making sure
the gear box drive shaft is facing the correct way.
4
.
Attach the magnetic universal joint to the drive shaft of the gear box using
the fixing clip (Part number 911771)
5
.
Cut the control rod (Part number 146B/W) to the correct length and drill a
4.1mm hole right through the rod 14mm from both ends.
6
.
Attach the magnetic adaptor (Part Number 70723) to the top of the rod and
the crank (Part number 70421B/W) to the bottom of the rod by clipping a
fixing clip on either end (Part number 911770)
7
.
Lift the control rod up and allow the magnetic adaptor (Part number 70723)
to clip home onto the magnetic universal joint (Part number 70722).
