Call:
+44 (0)1268 570900
Fax:
+44 (0)1268 732509
Email:
enquiries@yewdale.co.uk
Visit:
www.yewdale.co.uk
3
R20B Low Voltage Battery 7.4v DC - Radio control battery motor
1
.
The standard universal metal brackets supplied with the blind may be top,
face or side-fixed. Fix brackets in place using the appropriate screws/plugs.
2
.
Check that the blind fits correctly. The pin-end is sprung for easy fitting, but
the pin should be depressed once in place. The fabric should roll off the back
of the barrel, unless ordered as reverse-roll.
3
.
Fix the control-end bracket using appropriate screws/plugs.
4
.
Locate the blind into the control-end bracket, and mark the position of pin-
end bracket.
5
.
Remove the blind and fix the pin-end bracket using appropriate screws/
plugs.
NB.
To operate correctly, the blind MUST be fixed level.
6
.
Insert the pin-end of the blind into the bracket. Press the blind against the
bracket to depress the sprung pin, and insert the lug on the control-end into
its bracket until it drops into place.
7
.
For programming instructions, please refer to enclosed leaflet (sheet 1023).
NB.
Large blinds are heavy and it is important that the correct fixings are used.
If unsure, seek expert advice.
