YewdaleDefiant VL30 Single Draw R/H Control, Manufacturing Instructions

YewdaleDefiant

®  

Manufacturing instructions  

Part no: 998

4

VL30 Single Draw R/H Control:

1

.

Check the profile - part number (927000W), and spline – (927006), are free 

from damages

2

.

Cut the profile (927000W) 17mm less than the blind width

3

.

Cut spline (927006) 28mm less than the blind width.

4

.

Build part 927001RW/LW using the five components supplied, leaving the 

screw cover cap off at this stage.

5

.

Insert spline into drive end of control set (927001RW if right hand control 

or 927001LW if left hand control) and drill a hole through the connected 

parts with a 2mm drill bit and secure it in place with pin (927013), using pin 

hammer.

6

.

Select the appropriate trucks:

• If left hand control and 127mm, use 927002L

• If right hand control and 127mm, use 927002R

• If left hand control and 89mm, use 927003L

• If right hand control and 89mm, use 927003R

7

.

Using the formula below, calculate the amount of trucks needed.

  Actual blind width ÷ actual link length

For example, for a 400mm blind:

89mm louvre (the actual link length is 79mm) 400÷79mm = 5pcs

127mm louvre (the actual link length is 115mm) 400÷115mm = 4pcs

Round the figure up to next whole number.

Manufacturing Instructions

YewdaleDefiant

®

 Vertical blinds (VL30 Single Draw R/H Control)