1. Back Wheel Installation:
Turn the car over and make sure that it is stable. Cut the tape off of the gear
box, and then remove the protective jacket on the rear axle. Smear lube oil on
both ends of the rear axle. Install, in order, the fixment, the driving wheel (this
wheel has a place for the fixment), Metal gasket, pin, and then fasten the wheel
cover. On the other side install a Metal gasket, wheel, Metal gasket, pin,
wheel cover. (The rear wheel installation is completed)
2. Front Wheel Installation
Smear lube oil evenly on the left and right of front axle. Then put on the metal
gasket, wheel, metal gasket, put on the pin and the wheel cover for the left and
right axle. (Front wheel installation is completed)
3. Seat Installation
Connect both plugs from the battery and the PCB under car (black wire
connected the black terminal, red wire connected the red terminal).
Unfasten the seat belt and then put the belt sides over the side of the car. Insert
the seat, first the hooks near the shoulder should be put in the corresponding
holes on the car, then line up the locks with the bottom of the seat. Use a
screwdriver or coin to turn the “lock” logo. Double check that the seat is
locked in place.