2.4G remote control
1, 1) open the batteries box and put in 2 AAA batteries
2)
then press any button on remote control, the light on remote control will
start flashing then start the car, the light on remote control will turn off
for a second, then it will flicker at a high frequency, then 2.4G was
successfully matched to the car.
3)
After matching to the 2.4G, the light on remote control is fast flashing as
default.
Press one time on speed adjust button, the car’s speed will change to medium
speed. Press one more time the speed adjust button, the car’s speed will change
to slow speed. There are three different light flicker frequency, for three
different speeds
.
2, when press the forward/backward/left/right button, the car will go
forward/backward, turn left/right.
3, when the user presses the “pause” on remote control, remote control cannot
control the car, it will change to Manual Status Control.
Battery Charging
1. Before Charging, turn off the car and check power supplier input must be
comply with charger input, otherwise do not use it .
2. Charging slot is on the left under the seat pad. To insert the input plug to the
110V socket, and then insert the output plug into charging socket. The
indicator light on the charger will turn on. The battery charge is working.
3. When you use it for the first time, it has to be charged for 12 hours, but not
more than 15 hours. In future general charging time is 8 to 10 hours, but no
more than 24 hours.
4. After fully charged, remove the charger and the car can be used.
Attention
1. Charging must be done by adults
2. The charger is not a toy, please do not give children to play, and cannot be
Voice repeat button
