YG125-30B Maintenance Manual
Magneto and starting system
86
Edge ruler
6.
To install the double-linked gear cove:
⑴
Clean up the left front cover and parts
,
mount the
starting idle gear, double-linked gear, etc.
⑵
The O-ring into the double gear cover
,
š
In case of
O-ring aging, prolonging or deforming, replace it.
⑶
Mount the double-linked gear cove,
⑷
screw up to the torque of 8-12N.m
Notice:
Never let adhere to the left crank conical surface and
rotor tapered surface.
The disk gear shall only be capable of rotating
clockwise flexibly relative to the rotor.
Use the thread retaining adhesive LOCTITE 648 while
assembling the pressure plate bolt.
Warning
Thread retaining adhesive LOCTITE243 must be
applied to the rotor retaining nut M12 while
assembling, with the tightening torque being 45N.m.
Check
1
、
Check the spline gear of output shaft of the starting
motor for defect, squeezing, deforming, etc.
2
、
Check the idle gear and double-linked gear for missing
teeth, etc.
3
、
Check the idle gear shaft and double-linked gear shaft
for bending.
4
、
Check the rotating flexibility and unidirectivity of the disk
gear (relative to clockwise rotor rotation).
5
、
Check the axial play of the disk gear, generally not less
than 0.4mm.
6
、
Measure the disk gear diameter, the maintenance
limit:
≥φ
42.084mm
Double-linked gear cover
Double-linked gear
Vernier calipers
Outside micrometer
Summary of Contents for YG125-30B
Page 99: ...YG125 30B Maintenance Manual Frame and exhaust system 106 10 Frame and exhaust system...
Page 130: ...YG125 30B Maintenance Manual Illumination signal system 136 Circuit schematic drawing...
Page 141: ...YG125 30B Maintenance Manual Engine management system 147 Circuit schematic drawing...
Page 151: ...YG125 30B Maintenance Manual Electrical System Diagram 157 19 Electrical System Diagram...