YG125-30B Maintenance Manual
Crankcase, crankshaft and Shift mechanism
96
Replace washer with new ones after being removed.
Apply the thread retaining adhesive LOCTITE 648 while assembling the stud bolt.
Notice:
Do not the sealing surface, and assemble the driven shaft bearing with the side with oil seal facing inwards.
No.
Procedure
Quantity
Remarks
Removing order
Installation is in the reverse order of removal
1
Right hand crankcase
1
2
Balance shaft bearing
6302
1
Apply engine oil while assembling
3
Driving shaft bearing
62/22/C3
1
Let the oil seal side face inward and apply engine
oil while assembling
4
Gear shift shaft oil seal
18x34x5
1
Apply engine oil while assembling
5
Driven shaft bearing
60/18RLYAB
1
Let the oil seal side face inward and apply engine
oil while assembling
6
Driving shaft bearing pressure plate
1
7
Stud bolt M6
×
16
2
Use thread retaining adhesive LOCTITE 648
while assembling
Crankshaft and balance shaft
To remove the crankshaft and balance shaft:
1.
Remove the (left hand) crankcase (See
“
Removal of
left hand crankcase").
Summary of Contents for YG125-30B
Page 99: ...YG125 30B Maintenance Manual Frame and exhaust system 106 10 Frame and exhaust system...
Page 130: ...YG125 30B Maintenance Manual Illumination signal system 136 Circuit schematic drawing...
Page 141: ...YG125 30B Maintenance Manual Engine management system 147 Circuit schematic drawing...
Page 151: ...YG125 30B Maintenance Manual Electrical System Diagram 157 19 Electrical System Diagram...