YG125-30B Maintenance Manual
Crankcase, crankshaft and Shift mechanism
97
Crank-shaft
Balance shaft
2.
Remove the balance shaft.
3.
Remove the crankshaft.
Notice:
While removing, you may strike the balance shaft and
crankshaft gently; however, always avoid damaging
them.
To mount the crankshaft and balance shaft:
1.
Place the right hand crankcase assembled with
variable transmission system (driving/driven shaft,
etc.) on the assembly operating table, and use a
high power electric drier to heat the right crankcase
body crankshaft bearing until the temperature at the
inner circle of the bearing reaches 106
℃
, and then
assemble the crankshaft.
2.
Use a high power electric drier to heat the right
crankcase body balance shaft bearing
until the
temperature at the inner circle of the bearing
reaches 106
℃
, and then assemble the balance shaft.
Remember to align the markers on the driving and
driven gears.
3.
Mount the left hand crankcase (See
“
Installation of
crankcase").
Notice:
Only assemble when the temperature reaches 106
℃
,
otherwise it can
’
t be assembled. Never savagely
strike it!
The markers on the driving and driven gears must be
aligned.
Removal and installation of crankshaft and balance shaft
Electric drier
Balance shaft
Crank-shaft
Aligning the markers
3
2
1
Summary of Contents for YG125-30B
Page 99: ...YG125 30B Maintenance Manual Frame and exhaust system 106 10 Frame and exhaust system...
Page 130: ...YG125 30B Maintenance Manual Illumination signal system 136 Circuit schematic drawing...
Page 141: ...YG125 30B Maintenance Manual Engine management system 147 Circuit schematic drawing...
Page 151: ...YG125 30B Maintenance Manual Electrical System Diagram 157 19 Electrical System Diagram...