ASSEMBLY INSTRUCTIONS
5
III. Changing Personal Password:
1. Tap the setting buzzer for two drops to enter the password
Password setting: Enter the setting mode, enter the 4-8 password
press # to confirm, the buzzer drops 2 sounds and flashes
twice at the same time, then enter again, press # to confirm, the buzzer
often rings, the setting is successful.
2. If the password number is not within the specified range when entering the
password, or if the password is not the same as the first time when entering
password, or if the password is not the same as the first time when entering
exit the setting mode. The setting fails and needs to be reset.
IV. fingerprint setting :
1. After entering the setting mode, place your finger on the fingerprint reader
and move your finger four times after each beep of the buzzer.
After the last input, the buzzer often rings , and the setting is successful.
2. If you leave or cannot recognize the input during the setting process,
the buzzer beeps and exits the setting
mode. The setting fails and needs to be reset.
V. Changing the Administrator Password:
