YMGI: Your Modern Green Idea
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
34
WALL MOUNT CONTROLLER INSTALLATION AND SETUP (Optional)
The following is a brief overview of the Wired Tether Controller installation. See Owner's Manual for more detailed
instructions for setup and operation.
Preparation for Installation
Select a proper location on the wall for mounting the Tether
Controller. Install switch box, if required by code. The maximum wire
length between indoor and Tether Controller is 30-ft. Run
communication cable (as desired) between indoor unit and selected
wall mounting location. See Indoor Unit wiring section for instruction
to connect the Wired Tether Controller to the indoor unit.
Wired Tether Controller Installation
Pull communication cable through switch box (if one is used) and
Wired Tether Controller back plate. Securely fasten back plate to the
switch box or wall.
Locate wire terminals X1 and X2 on rear of Tether Controller panel.
Carefully connect wire X1 to indoor unit terminal H1 and X2 to indoor
unit terminal H2. Verify wires are secure, not loose and no external
force on wires affects the connections at the terminals. Push extra
cable into wall and secure controller panel to back plate mounted on
the wall.
NOTE: Do not cut or splice communication cable.
Follow the instructions supplied with the Owner's Manual for setup
and operation.