YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
14
BRIEF INTRODUCTION TO MINI SPLIT WALL MOUNT SYSTEM
Mini Split Wall Mount Systems are designed for high performance, easy installation and service. Each system consists of
one or several indoor units and one outdoor unit, which are connected by one set or several multiple sets of
interconnection refrigerant pipes and electric wires.
As shown in the following sample picture of outdoor unit, air is drawn through the coil from the rear side and then
discharged from the front side. In cooling mode, air passing through coil is heated; in heating mode, air passing through
coil is cooled.
Sample Wall Mount Mini Split System (For Continuous Engineering Improvement and Various Marketing Needs
and Actual Part Availability, Unit Appearance Subject to Change or Update Continuously without Prior Notice)
Outdoor unit(s) provides the electrical and thermal power for the whole system. Electrical and thermal components such
as compressors and motors and heat exchange coils and others, are incorporated into the cabinet in an optimized order.
They can be either hung on the wall or installed on the ground. Once stacking or bracket kit is used, some outdoor units
can be stacked 2 or 3 units high, upon unit size and applications. Air is discharged horizontally, quietly and smoothly.
These units are a perfect fit in locations where installation and applications of general up-flow condensing units are
limited, such as apartments, condos, lofts, multi-families and high-rise buildings and others named or unnamed.
Indoor unit(s) delivers the thermal and acoustical comfort to the rooms. Air is drawn through the coil from the front or
topside and then discharged from the bottom. In cooling mode, air passing through coil is cooled; in heating mode, air
passing through coil is heated. Air is filtered or treated by the built in mechanism (washable or enzyme equipped or
electrostatic powered filter, varies from model to model), before being delivered into the room, with more than enough
comfort and care, at a wide angle (swing or not, varies from model to model).
Apartments
Hotels
Homes
NOTES: Since ductless system is not designed to incorporate or use with ducted return or discharge tunnels,
one single-zone unit SHALL NOT be used to take care of the cooling or heating load of more than one-story
room. Several single-zone ductless systems or multiple-zone ductless systems shall be proper in this regard.
These units are designed for applications at:
Residential
Light commercial
Institutional
Industrial
Commercial
Hospital
